BC360L series general weighing controller is embedded with all kinds of basic weighing setpoint control sequences. This feature makes it possible to be applied in most industrial weighing fields with economical cost spending. The real-time weighing signal can be converted into standard industrial communication signals, integrating field display and remote transmission, quantitative control and setpoint comparison at the same time, widely used in metallurgy, chemical industry, building materials, feed, textile, labs, material force analysis and other industries.


  • Compact Panel Mount structure, save installation space
  • New generation of embedded high speed processor, strong on anti-interference
  • Optimized digital filter and quick following technology
  • 4 ~ 20mA / 0 ~ 10V analog out available
  • Over/under limit alarming
  • Embedded material transfer control
  • Embedded Setpoint comparison function
  • Check-weigh control
  • Auto zero tracking available
  • Power-up zero available
  • Isolated RS232 / RS485 serial interface
  • Standard MODBUS RTU protocol
  • DC24V power supply




Enclosure Front plate: Aluminum , IP65. Case: Aluminum
Run Mode 2-speed material transfer mode, Setpoint comparison,Over/under, Check weigh,Reduction weigh,Peak force measurement,Gross/net fill
Signal Range -20mV~+20mV Increments 1,2,5 x 10(n=-3 ~1)
Max. Sensitivity 0.5uV/d Max. Resolution 1/50,000
FS Drift 3ppm/°C Linearity 0.003%FS
AD Refresh Rate 100Hz Cells Load Four (4) 350 ohm load cells
Display 7-digit 0.4’ segment LED
Keypad 4 tactile-feel keys; polyester overlay
Discrete I/O 2xDI,3x Relay DO

2 Inputs; 3 Outputs(220VAC @ 5A)

USART COM1: RS232; COM2: RS485
Serial Protocol MODBUS-RTU, Command output, Continuous Output
Option 4~20mA/0~10V, Profibus DP
Power Supply 18~30DCV, 60mA
Operating Temperature -10°C ~ +40°C,Relative humidity:10%~90%,non-condensing